Linde AGA AQVIA User Manual page 7

Removing the gas cylinder
Place the sparkling water maker on a flat surface and remove the back section by pressing
the button on the back and then pushing the back section first up and then out. Unscrew
GB
the cylinder, at which point the sparkling water maker will tip forwards slightly. Tilt the
sparkling water maker a little further forwards and lift out the cylinder.
Filling the water bottle
Clean the bottle before use. Do not use water
hotter than 40 C. Fill the bottle with cold water
o
up to the maximum volume mark. If the bottle is
overfilled, water can enter the machine and leak
out. For best results, use cold water; the colder
the water, the greater the volume of gas that
can be dissolved. It is therefore a good idea to
store an extra bottle of water in the fridge. Make
sure, however, not to keep the water for too
long in the bottle as it might become stale.
Important! Never carbonate anything other than pure drinking water, as sugar
or other additives might cause the pressure relief valves to stick, rendering the
machine unsafe to use.
7