Linde AGA AQVIA User Manual page 6

Using the sparkling water maker
Your new sparkling water maker enables you to carbonate your own water, which you
can then flavour with concentrates from AQVIA
the AGA 425 g carbon dioxide gas cylinder. When the cylinder is empty, a replacement
can be bought from the store where you made your original purchase and the old bottle
returned for deposit.
Inserting the gas cylinder
Remove the seal and the protective cap from the cylinder. Keep the cap in a safe place as
it will be needed when you replace the cylinder when empty. Place the sparkling water
maker on a flat surface and remove the back section by pressing the button on the back
and pushing the back section first up and then out.
Tilt the sparkling water maker forwards and insert the gas cylinder through the opening
in the bottom of the machine so that the cylinder is standing on the work surface. Gently
tilt the sparkling water maker back so that the upper part of the machine rests against the
threaded neck of the cylinder.
Screw the cylinder into the machine as far as
it will go (see illustration), at which point the
sparkling water maker will have returned to
its original resting position. Make sure that
the cylinder is firmly in place.
Slide the back section back into its guide
grooves and push it down until the locking
mechanism clicks back into place.
. To carbonate your own water, you need
®
6