Table of Contents
Advertisement
Diagonal Scanning (default = off)
JAZZ Joystick can be programmed to scan only in the salient directions (up, down, left and right)
or may be programmed to include the diagonals too. The decision on whether to allow diagonal
scanning is dependent on the user's cognition but also upon what software is being used. If using
Grid 3*, do not enable diagonal scanning. To change this setting, press and hold the left button
while in Learn until a two-tone beep is heard. A falling tone means that diagonals are not permitted,
whereas a rising two-tone beep means they are permitted.
Note that this setting is used only when in Switch Scanning mode. Diagonal Cursor Movement is a separate setting- see above.
Buzzer On/Off (default = buzzer on)
JAZZ Joystick is fitted with a buzzer which gives an audible indication of when the joystick first
operates. When JAZZ Joystick is used in a classroom setting where there may be many units in
close proximity, it may be beneficial to turn off the buzzer. To achieve this, press and hold the right
button while in Learn, until a two-tone beep is heard. A falling tone means that the buzzer is now
disabled, whereas a rising tone means it is enabled.
Note that this setting applies to both Mouse and Switch Scanning modes and may be changed in either.
All of the above settings may be changed as often as required while in Learn, allowing you to
experiment with the settings until the best configuration is found. Once you are happy with them,
they may be stored in non-volatile memory by pressing and holding the middle button once again,
until the warbling tone is heard. Normal operation then resumes with the new settings.
Please note that the unit automatically leaves Learn, and any changes are discarded, if the settings remain unchanged for
more than a minute.
The left socket has exactly the same function as the left button, which may be left click, right
click (when left-handed operation is enabled) or double-click (when both double-click and left-
handed operation are enabled). Both the left button and the left socket work simultaneously
with the same function at all times.
Your JAZZ Joystick has no user serviceable parts. If repair is necessary the unit should be returned
to Pretorian Technologies Ltd or an authorised distributor.
Your JAZZ Joystick is warranted for 24 months from the date of purchase against defects
in manufacture or component failure. The unit is designed for domestic, educational and
commercial applications. Use outside these areas will invalidate the warranty. Unauthorised
repair or modification, mechanical abuse, immersion in any liquid or connection to any equipment
other than a host computer will invalidate the warranty.
Left Socket
Maintenance
Warranty
Advertisement
Table of Contents
