Table of Contents
Advertisement
WARNINGS
Warning
To avoid the risk of fire, explosion, or electric shock, this product should be installed,
inspected, and maintained by a qualified electrician only, in accordance with all
applicable National electrical codes.
Warning
To avoid electric shock:
Be certain electrical power is OFF before and during installation and maintenance.
•
The Power Supply must only be connected to Dialight Corp approved products.
•
Warning
To avoid explosion:
Do not connect to equipment that the Controller is not intended for.
•
Ensure the marked T Rating is less than the ignition temperature of the Hazardous
•
Atmosphere.
Do not operate in ambient temperatures above those indicated on the Products label.
•
Do not operate if the fasteners are not properly tightened.
•
Do not operate in Hazardous locations with the Enclosure cover open.
•
Warning
To avoid explosion (Continued):
EXPLOSION HAZARD- DO NOT DISCONNECT EQUIPMENT UNLESS POWER
•
HAS BEEN SWITCHED OFF OR THE AREA IS KNOWN TO BE NON-
HAZARDOUS.
AVERTISSEMENT – RISQUE D'EXPLOSION – AVANT DE DECONNECTER
•
L'EQUIPEMENT, COUPER LE COURANT OU S'ASSURER QUE
L'EMPLACEMENT EST DESIGNE NON DANGEREUX.
DO NOT REMOVE OR REPLACE WHILE CIRCUIT IS LIVE UNLESS THE AREA IS
•
KNOWN TO BE FREE OF IGNITIBLE CONCENTRATIONS.
THIS EQUIPMENT IS SUITABLE FOR USE IN HAZARDOUS OR NON-
•
HAZARDOUS LOCATIONS ONLY. REFER TO PRODUCT FOR RATINGS
EXPLOSIONS HAZARD – DO NOT DISCONNECT WHILE THE CIRCUIT IS LIVE OR
•
UNLESS THE AREA IS KNOWN TO BE FREE OF IGNITABLE
CONCENTRAITIONS.
Dialight Corporation 1501 Route 34 South
Tel: 732.919.3119 Fax: 732.751.5778 Web: www.dialight.com
Farmingdale NJ 07727
Page 2 of 21
Document No.
9100-127-2044-99 Rev C
Release Date: August 2020
Advertisement
Table of Contents
