Table of Contents
Advertisement
TRANSLATOR & RS485 JUNCTION BOARD
NOTE: Rotary switch SW1 on the Translator must be set to a unique address for each
Power Supply connected to the Controller.
NOTE: If ordered as a system, typically SW1 will be factory set per this table (i.e. JB4-
xxxxxxxxxx would have SW1 set to Position 3). This should be confirmed by the
installer. Replacement plates will typically have SW1 set to 0; the switch must be set by
the installer to match the address that is being replaced.
Dialight Corporation 1501 Route 34 South
Tel: 732.919.3119 Fax: 732.751.5778 Web: www.dialight.com
SW1 Position
MIOL No.
0
1
2
3
4
5
6
7
Page 11 of 21
Document No.
9100-127-2044-99 Rev C
Release Date: August 2020
1
2
3
4
5
6
7
8
Farmingdale NJ 07727
Advertisement
Table of Contents
