Hammer stop switch and drill stop switch
№
Symbol
001
002
003
If you only want to use the device as a drill, you can switch off the hammer function. Therefore, turn the
switch (7) on top of the device to the corresponding symbol 002. To re-activate the hammer function,
the switch (7) must be re-adjusted to the symbol 001.
You may switch off the drilling function of the percussion drill as well if you only want it to hammer/chisel.
Therefore, turn the switch (6) in the handle interstice to the symbol 003. To re-activate the drilling func-
tion, the switch (6) must be re-adjusted to the symbol 001.
Please note that to perform percussion drilling, both switches must point at the corresponding sym-
bol.
Important!
Only impost a low pressure while percussion drilling. Too high a pressure leads to the
motor being unnecessarily charged. Regularly check the drill bits. Re-sharpen or replace blunt drill bits.
Maintenance
•
Do pull out the plug before performing any maintenance or cleaning work.
•
Always keep the device tidy.
•
Never use caustic detergents to clean the plastic parts of the device.
•
To avoid dust from collecting, you should remove all dust from the vents with the help of pres-
surised air (max. 3 bar) after having finished your work.
•
Regularly check the carbon brushes. Dirty or used carbon brushes lead to excessive spark
formation and loss of performance.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Meaning
Percussion drilling
Drilling
Hammering/chiselling
Item 62555
Page 6
08
2021-1