Advertisement
Quick Links
Operation Manual
Hammer Drill
62555
Illustration similar, may vary depending on model
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Due to further developments, illustrations, functioning steps and technical data can differ insignificantly.
Updating the documentation
If you have suggestions for improvement or have found any irregularities, please contact us.
Advertisement
Related Manuals for WilTec 62555
Summary of Contents for WilTec 62555
- Page 1 Operation Manual Hammer Drill 62555 Illustration similar, may vary depending on model Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Due to further developments, illustrations, functioning steps and technical data can differ insignificantly.
- Page 2 All rights re- served. The WilTec Wildanger Technik GmbH cannot be held accountable for any possible mistakes in this operating manual, nor in the diagrams and figures shown.
- Page 3 • Flat chisel (25×250 mm) SDS Plus • Sharp chisel (250 mm) SDS Plus • Lubricating grease • Dust protection • 2 × carbon brushes • © by WilTec Wildanger Technik GmbH Item 62555 Page 3 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
- Page 4 To protect your fingers from contusion and abrasion, always wear working gloves. • Vibrations might cause hand-arm-system injuries. Make sure to be exposed to vibrations the less possible. © by WilTec Wildanger Technik GmbH Item 62555 Page 4 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
- Page 5 “min.” (lowest possible speed) and “max.” (highest possible speed) as well as intermediate values. Dust collecting device (Abb. 7) Place the dust collecting device over the drill before performing hammer-drill work over head. © by WilTec Wildanger Technik GmbH Item 62555 Page 5 http://www.WilTec.de http://www.aoyue.eu...
- Page 6 (max. 3 bar) after having finished your work. • Regularly check the carbon brushes. Dirty or used carbon brushes lead to excessive spark formation and loss of performance. © by WilTec Wildanger Technik GmbH Item 62555 Page 6 http://www.WilTec.de http://www.aoyue.eu...
- Page 7 Exploded view and parts list © by WilTec Wildanger Technik GmbH Item 62555 Page 7 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
- Page 8 Ball bolt Hoop O-ring Holder Handle support O-ring Sliding needle bearing Auxiliary handle Spin sleeve Washer Dust protection D-shaped rubber seal Small armature Toolbox Spring Gear © by WilTec Wildanger Technik GmbH Item 62555 Page 8 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
- Page 9 This logo indicates that this electric equipment must not be disposed with the domestic waste. The company WilTec Technik GmbH has been registered in the German registry EAR under the WEEE- registration number DE45283704. Disposal of used electrical and electronic appliances...