Operating Instructions; Cleaning The Air Filter - Stihl FS 94 Instruction Manual

English
2.
► Disconnect wire rod from the transport guard.
► Swing wire rod outwards.
► Fit the transport guard on the cutting attach‐
ment from below.
► Hook wire rod to the transport guard.
► Swing wire rod into position.
28
1.
2.

16 Operating Instructions

16.1 During break-in period
A factory-new machine should not be run at high
revs (full throttle off load) for the first three tank
fillings. This avoids unnecessary high loads dur‐
ing the break-in period. As all moving parts have
to bed in during the break-in period, the frictional
resistances in the engine are greater during this
period. The engine develops its maximum power
after about 5 to 15 tank fillings.
16.2 During Operation
After a long period of full throttle operation, allow
the engine to run for a short while at idle speed
so that engine heat can be dissipated by the flow
of cooling air. This protects engine-mounted
components (ignition, carburetor) from thermal
overload.
16.3 After Finishing Work
Storing for a short period: Wait for the engine to
cool down. Empty the fuel tank and keep the
machine in a dry place, well away from sources
of ignition, until you need it again. For longer out-
of-service periods – see "Storing the Machine".

17 Cleaning the Air Filter

17.1 If there is a noticeable loss of
engine power
► Set knob for warm start (1) to g
► Turn screw (2) in filter cover (3) counterclock‐
wise until the cover is loose
► Remove filter cover (3)
► Clean away loose dirt from around the filter
16 Operating Instructions
1
0458-593-8321-C