Stihl FS 94 Instruction Manual page 15

6 Mounting the Loop Handle
6.3 Mounting the Loop Handle
without Barrier Bar
7
8
6
1
► Insert the clamp (3) in the loop handle (4) and
position them together on the shaft (5)
► Position the clamp (6) against the shaft
► Line up the holes
► Fit the washer (8) on the screw (7) and insert
the screw in the hole. Fit the square nuts (1)
and screw it down as far as it will go
► Go to "Securing the Loop Handle"
0458-593-8321-C
7
8
4
3
5
1
6.4 Orienting and Securing the
Loop Handle
A
The loop handle can be adjusted to suit the
height and reach of the operator and the applica‐
tion by changing distance "A".
Recommendation: distance (A): about 20 cm
(8 in)
► Slide the loop handle to the required position
► Line up the loop handle (4)
► Tighten down the screws until the loop handle
can no longer be rotated on the shaft. If no
barrier bar is fitted – lock the nuts if necessary
English
4
15