Troubleshooting - Electrolux EOD3H54X User Manual

30 www.electrolux.com
Step 8
Step 9
The screen-printing zone must face the
inner side of the door. Make sure that
after the installation the surface of the
glass panel frame on the screen-printing
zones is not rough when you touch it.
When installed correctly the door trim
clicks.
Make sure that you install the internal
glass panel in the seats correctly.
12.6 How to replace: Lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
Turn off the oven. Wait un‐
til the oven is cold.
Back lamp
Step 1
Step 2
Step 3
Step 4

13. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
Clean the glass panels with wa‐
ter and soap. Dry the glass pan‐
els carefully. Do not clean the
glass panels in the dishwasher.
After cleaning, install the glass
panel and the oven door.
Before you replace the lamp:
Step 1
Disconnect the oven from
Turn the glass cover to remove it.
Clean the glass cover.
Replace the lamp with a suitable 300 °C heat-resistant lamp.
Install the glass cover.
Always hold the halogen lamp with a
cloth to prevent grease residue from
burning on the lamp.
Step 2
the mains.
13.1 What to do if...
In any cases not included in this table
please contact with an Authorised
Service Centre.
Step 3
Put a cloth on the bottom
of the cavity.
A