Controller Features - Kenmore 625.384200 Use & Care Manual

EXTRA RECHARGE
Sometimes, a manually initiated recharge (regeneration)
may be desired, or needed. Two examples are:
You have used more water than usual (guests visiting)
and you may run out of soft water before the next
automatic regeneration.
You did not add salt to the softener before it ran out.
Add salt to the softener before regenerating.
You can start a regeneration immediately, or you can
set the controller to regenerate at the next preset
recharge time (2:00 AM, or as set).
RECHARGE NOW
Press the REGENERATION button and hold for 3 sec-
onds, until the words "RECHARGE", "Serv" and "Fill"
begin to flash in the display. The softener enters the fill
cycle of regeneration immediately. This regeneration
will take about 2 hours to complete. Then, you will
have soft water again.
NOTE: If the "Clean Feature" is set ON, the normal
regeneration cycle is preceded by a cleaning
backwash and rinse. The words "CLEAN" and
"Bkwsh" or "Rinse" flash in the display, along
with the minutes of the clean cycle remaining.
RECHARGE TONIGHT
Press and release (do not hold) the REGENERATION
button. "RECHARGE TONIGHT" will begin flashing in
the display, and the softener will begin regeneration at
the next preset recharge time (2:00 AM, or as set). If
you decide to cancel the regeneration before it starts,
press and release the REGENERATION button once
more. "RECHARGE TONIGHT" will stop flashing in the
display.
Questions? Visit www.kenmorewatersolutions.com or call 1-800-695-2761.
16

Controller Features

SALT MONITOR SYSTEM
The water softener has a salt monitor indicator light to
remind you to add salt to the storage tank.
NOTE: You must set salt level each time salt is added
NOTE: The salt monitor system estimates salt levels, and
To set this monitor system:
1. Lift the salt lid and level the salt in the storage tank.
2. The salt level scale, on the brinewell inside the tank,
Level
3. Press the SET SALT LEVEL button as many times as
Figure 22
4. If you want to turn the salt monitor off, press the SET
Figure 23
to the water softener.
accuracy will vary with different salts.
has numbers from 0 to 8 (see Fig. 24). Observe the
highest number the leveled salt is at, or closest to.
SALT
LEVEL
Salt Level
Brinewell
Salt
Numbers
necessary to make the salt level bars in the display
(see Fig. 24) match the number on the brinewell. At
level 2 or below, the "Low Salt" indicator will flash.
SALT LEVEL button past 8, until "OFF" shows in the
display next to the number 8.
press for tonight
Bars
hold for immediate
Set
Salt
Level
Figure 24
Figure 25
L