Preparing Storage And Further Use; Disposal; Environmental Protection - Bosch Rexroth 4WRPEH6 3X Operating Instructions Manual

36/44

Disposal

Bosch Rexroth AG, 4WRPEH6_3X, 4WRPEH10_3X, 4WRPE6_3X, 4WRPE10_3X, 4WRLE_4X; RE 29118-B/09.2021
3. Switch off your system and separate the electric voltage supply and protect the
system against restarting before all disassembly work.
4. Provide for a clean environment during the disassembly.
Prepare a container or a pan for collecting the leaking hydraulic fluid.
5.
6. Only use suitable tools to loosen the mounting screws of the valve.
7. Remove the mounting screws and remove the valve from the valve contact
surface.
8. Collect the escaping hydraulic fluid in the provided container and dispose of it
properly.
9. Lift the valve from the installation position.
10. If the valve is to be returned to the manufacturer for repair, close the valve
connection surface using the protective plate supplied or protect it using
equivalent packaging in order to avoid contamination and damage.
11. Close the subplate in order to avoid contamination of your system.
In case of new installation and/or replacement of the hydraulic valve, please refer to
chapter 7 "Installation".

11.4 Preparing storage and further use

To prepare the valve for storage and further use, proceed as follows:
▶ Only use the original packaging for storage.
▶ Comply with the admissible storage temperature range specified in chapter 6.1
"Storing the valve with IO-Link interface".
▶ Protect the valve from dust and humidity.
12 Disposal

12.1 Environmental protection

Careless disposal of the valve may cause environmental pollution.
▶ Dispose of the product therefore in accordance with the currently applicable
national provisions in your country.
▶ Please observe the following information for environmentally-friendly disposal of
the valve.