Page 1
S2719H/S2719HN/S2719NX 1. Disassembly Procedures: Step Figure Remark Turn off power, S1.Before Unplug external cables disassemble from product To remove the stand: 1. Press and hold the stand release button. 2. Lift the stand up and away from the monitor.
Page 2
S2719H/S2719HN/S2719NX Use a Philips-head screwdriver to remove 2 screws for unlocking mechanisms. (No.1~2 screw size=M3x3; Torque=6±1kgf.cm) S3.Remove the Rear Cover Use Penknife to separate the bezel and rear cove follow the arrows in sequence, then you can take out rear cover.
Page 3
Use a Philips-head screwdriver to remove 6 screws for remove S5.Remove the speaker. speaker (No.1~6 screw size=M3x6; Torque=6±1kgf.cm) Only for S2719H model Use a Philips-head screwdriver to remove 4 screws for remove S6.Remove the mainframe mainframe (No.1~4 screw size=P3x4; Torque= 3±0.5kgf.cm)
Page 4
S2719H/S2719HN/S2719NX S8. Remove the panel FFC cable and the converter board to panel cable S9.The panel...
Page 5
S2719H/S2719HN/S2719NX S10.Remove the Key Board S11.The Middle frame Use a Philips-head screwdriver to remove 5 screws for remove main S12.Remove main board and converter board and board converter board (No.1~5 screw size=D3x6; Torque=6±1kgf.cm)
Page 6
S2719H/S2719HN/S2719NX electrolyte capacitors S13. The (height < 25mm, Converter Board diameter< 25mm) S14.The Main Frame...
S2719H/S2719HN/S2719NX 2. Product material information The following substances, preparations, or components should be disposed of or recovered separately from other WEEE in compliance with Article 4 of EU Council Directive 75/442/EEC. Capacitors / condensers (containing No used PCB/PCT) Mercury containing components...