Safety Rules For Working Equipment; Unpacking And Checking Contents - KNOVA KN CP-2042B Operator's Manual

ADDITIONAL SAFETY RULES FOR DUST COLLECTOR
• Keep hair, loose clothing, fingers, and all parts of body away
from openings and moving parts.
• Extension cords in poor condition or that are too small can pose
fire and shock hazards. When using an extension cord, be sure
it is in good condition. See "Extension cords" in the
"Operation" section for proper wire sizes.

SAFETY RULES FOR WORKING EQUIPMENT

1. Read and become familiar with the entire operating
manual.
2. Keep guards and cover in place and working order.
3. Always use safety glasses. Also use face or dusty.
Everyday eye glasses only have impact resistant lenses,
they are not safety glasses.
4. Keep work area clean. Cluttered areas and benches
invite accidents.
5. Don't force tool. It will do a better and safer job at the
rate for which is was designed.
6. Avoid accidental starting. Make sure switch is in "OFF"
position before plugging in cord.
7. Disconnect tools before servicing and when changing
accessories such as blades, cutters.
8. Don't over reach. Keep your proper footing and balance
at times. For best footing wear rubber soled footwear.
Keep floor clear of oil, scrap wood, etc.
9. Wear proper apparel. Loose clothing or jewelry may
get caught in moving parts. Wear protective hair
covering to contain long hair.
10. Make workshop child proof. Place a padlock on the switch
when blade saw is not in use and store the key in a safe
location.
11. Remove adjusting keys and wrenches. Form the habit
of checking to see that keys and adjusting wrenches
are removed from tool before turning it on.

UNPACKING AND CHECKING CONTENTS

Unpack carton, check machine, to see parts listed below:
• Connect to properly, grounded outlet only
(See "Grounding instructions" on page 11)
Save these instructions
12. Avoid dangerous environment. Don't use power tools in
damp or wet locations. Keep your work area well
illuminated DO NOT USE in explosive atmosphere
(around paint, flammable liquids, etc.)
13. Keep children away. All vistors should be kept a safe
distance from work area, especially while operating unit.
14. Use the proper tool. Don't force tool or attachment to
do a job for which it was not designed.
15. Maintain tools in top condition. Keep tools sharp and
clean for best and safest performance. Follow
instructions for lubricating and changing accessories.
16. Secure your work. Use clamps or a vise to hold work,
when practical. It's safer than using your hand and
prevents round or irregularly shaped pieces from turning.
17. Check damaged parts. Before further use of the tool, a
guard or other part that is damaged should be checked
to assure that it will operate property and perform its
intended function check alignment of moving parts,
breakage of parts, mounting or any other conditions that
may affect its operations. A guard or other part that is
damaged should be properly repaired or replaced.
18. Use recommended accessories. Consult owner's manual.
Use of improper accessories could be hazardous.
19. Never stand on tool. Injury could occur from a fall.
20. Never leave tool running and unattended.
21. Always remove cord plug from electrical outlet when
adjusting, changing parts working on tool.
A. Hose
B. Collector body & Fan/Motor assembly
C. Collector body
D. Base plate
E. Upper bag support
F. Support
G. Inlet
H. Two bags
I. Packing
J. Four casters
K. Nuts, screws, washers, spring washers
and wrench
L. Outlet
M. Two hose clamp
2