Timer Control - Dimplex Winslow SWM3520-EU Owner's Manual

Operation
Changing the temperature unit (�C ↔ �F):
With Heat ON and display showing the set temperature, press and hold the Power
ON/OFF button on the touchscreen for 5 seconds. The display will flash 3 times and
units will switch from �F to �C or �C to �F.
Heater Enable & Disable Function:
From the touchscreen controls, press and hold the Heat Control icon for 10
seconds. The ember bed will flash six times to indicate that the heater function is
disabled. When the Heat Control button is pressed while the heat is disabled, the
ember bed will flash but the heater will not operate.
To enable the heater again, press and hold the Heat Control button for 10 seconds.
After the ember bed flashes for a second time, heat function is restored.
NOTE: This can only be done through the touchscreen controls.

TIMER CONTROL

The Timer Control button is used to activate or deactivate the sleep timer.
Pressing the Timer Control turns the timer ON and '8h' appears on the display.
Pressing the Timer Control button a second time within 10 seconds will turn the
timer OFF. To set the timer, use the Level Selection control to select the desired time
from the following: 8h, 1h, 2h, 3h, 4h, 5h, 6h, 7h.
The fireplace will shut off after the selected time period. Switching the fireplace OFF
with the Power ON/OFF will clear any timer setting.
EMBER BED
The ember bed button is used to change the ember bed color.
Press the ember bed button multiple times to cycle through color options. 'd8'
through 'd2' indicate different solid color options. d1 indicates the color rotation
option.
Use the Level Selection button while d2 through d8 is displayed to change the
brightness of the ember bed: 1- Low, 2- Medium, 3- High.
- 20 -
Operation
Use the Level Selection button while d1 is displayed to change the speed of the
color rotation: 1- Low, 2-Medium, 3- High.
Touch and hold the ember bed button for 5s, then enter into backlight mode, Press
multiple times to cycle through the following options:
Button Press Backlight Color Display Value
1st Press Yellow F4
2nd Press Blue F3
3rd Press Yellow & Blue F2
4th Press Color Rotation F1
5th Press OFF NONE
Use the Level Selection button while F4, F3 or F2 is displayed to change the brightness
of the backlight: 1- Low, 2-Medium, 3- High.
Use the Level Selection button while F1 is displayed to change the speed of the color
rotation: 1-Low, 2-Medium, 3-High.
LEVEL SELECTION BUTTON
The Level Selection button is used to adjust the Heat setting, timer setting, Flame ,
Ember bed and backlight Brightness, Color and Rotation speed. See relevant section
for more details.
- 21 - www.dimplex-fires.eu
EN