Honda HRR216VKA K5 Manual page 56

HRR216VKA
15. PINION GEAR
LUBRICATION
1. Remove the 8 x 12 mm wheel bolt and the rear
wheel.
2. Remove the wheel washer and the flat washer.
3. Remove the 13 mm circlip, pinion gear collar,
and the pinion gear.
4. Inspect the pinion gear and ratchet key for wear
or damage. Replace as necessary.
5. Apply Honda Marine extreme pressure NLGI #2
GC-LB grease or equivalent to the pinion gear,
axle, and ratchet spring.
IMPORTANT:
Only use an extreme pressure NLGI #2 GC-LB
wheel bearing grease. Proper application of the
correct grease is critical to ensure proper
operation.
DO NOT USE anti-seize, white lithium, silicone,
WD-40, or any other spray lubricant.
6. Reassemble in the reverse order of
disassembly.

PINION GEAR
COLLAR
RATCHET
KEY


RATCHET
SPRING
AXLE
FLAT WASHER
WHEEL WASHER
REASSEMBLY:
Install the washer as shown.
Install the curved wheel washer
in the direction shown.
MAINTENANCE
PINION GEAR
(12 tooth)

Install with the
punch mark
facing:
Left - inside
Right - outside
PINION GEAR
COLLAR
13 mm
CIRCLIP
WHEEL BOLT
REAR WHEEL
3-15