Table of Contents
Advertisement
CHAPTER -3: INSTALLING THE MACHINE
If the door of the machine does not close properly, check if the machine is stable
on the floor on which it stands; if not, adjust the feet and ensure its stable position.
Water connection
İndoor plumbing must be suitable for installing a dishwasher. We also recommend
that you fit a filter at the entrance of your house or apartment so as to avoid any
damage to your machine as a result of any contamination (sand, clay, rust etc.)
that might be occasionally carried in through the main water supply or the indoor
plumbing, and to forestall such complaints as yellowing and the formation of
deposits after washing.
After making connections, the tap should be turned on fully and checked for
water tightness. For the safety of machine, turn off the water inlet tap after
finishing each wash programme.
Water inlet hose
Do not use the water inlet hose of your old machine. Use
the new hose supplied with your machine. If you connect
a new or long - unused water inlet hose to your machine,
run water through it for a while before making the
connection. Connect the water inlet hose directly to the
water inlet tap. The pressure supplied by the tap should
be at a minimum of 0.03 Mpa and and at a maximum of
1 Mpa. If the water pressure is above 1 Mpa, a pressure-
relief valve should be fitted in between.
NOTE: An aquastop water spout is used in some
models. In the event of using Aquastop, a dangerous
tension exists. Do not cut Aquastop water spout. Do
not let it get folded or twisted.
Water outlet hose
The water drain hose can be connected either directly
to the water drain hole or to the sink outlet spigot.
Using a special bent pipe (if available), the water can
be drained directly into the sink via hooking the bent
pipe over the edge of the sink. This connection should
be between 50 and 110 cm from the floor plane.
EN-9
Advertisement
Table of Contents
