Warranty And Liability; Environmental Protection, Disposal; Connection Diagrams - Fein GRIT GI75 Series Manual

en
10
Noise emission values.
A-weighted emission
pressure power level
measured at the work-
place L (re 20 μPa), in
pA
decibels
Measuring uncertainty
K , in decibels
pA
Measured A-weighted
sound power level L
wA
(re 1 pW), in decibels
Measuring uncertainty
K , in decibels
wA
Operating conditions
Speed (rpm)
Material
Dimension
Grinding belt
REMARK: The sum of the measured emission value and
respective measuring inaccuracy represents the upper
limit of the values that can occur during measuring.
Wear hearing protection!
Measured values determined in accordance with the cor-
responding product standard.
Repair and customer service.
Repairs may be carried out only by qualified per-
sons in conformity with the valid regulations.
For repairs, we recommend our FEIN customer service
centre, the FEIN authorised service centres and FEIN
agencies.
When the machine's power supply cable is damaged, it
must be replaced using a specially prepared power supply
cable, available from your FEIN customer service agent.
The current spare parts list of this machine can be found
on the Internet under www.fein.com.
Daily maintenance
Blow out the ventilation slots (18) at the motor
housing and the marked locations with compressed
air (see Instruction label (27)).
Lubricate the machine daily (when in use) with
machine oil at the locations marked (see Instruc-
tion label (27)).
Check the drive disc (23) and the contact disc (21) for
wear and damage each time when replacing a grinding
belt. Have damaged parts replaced.
Loosen star-knob bolt (11).
Remove the chip/grinding-dust box (8) and dispose of
the metal dust.
Before emptying, the contents of the chip/grinding-dust
box must have cooled down sufficiently and may only be
disposed of in suitable containers.
Idle Sanding
80.5 94
4 4
90 100,5
2.5 2.5
3 000 3 000
– ST 37
– 8 x 40
GRIT by Fein
– 36Z
Mount the emptied chip/grinding-dust box again and set
the gap clearance of the grinding rest. (figure 1)
Tighten star-knob bolt (11).
Cleaning the exterior of the machine with compressed
air.
Lubricate the bearings of the tensioning device monthly
via the lubricating nipple (24).
If required, you can change the following parts yourself:
Grinding belt, spark guard

Warranty and liability.

The warranty for the product is valid in accordance with
the legal regulations in the country where it is marketed.
In addition, FEIN also provides a guarantee in accordance
with the FEIN manufacturer's warranty declaration.
The delivery scope of your machine may include only a
part of the accessories described or shown in this instruc-
tion manual.

Environmental protection, disposal.

Packaging, worn out machines and accessories should be
sorted for environment-friendly recycling.

Connection diagrams.

Type GI75, GI150 440/254 V, 400/230 V
Page 21
Type GI75, GI150 230 V, 220 V
Page 22
Type GI75, GI150 575/332 V
Page 23
Type GI75 2H, GI150 2H 440/254 V, 400/230 V
Page 24
Typ GI75 2H, GI150 2H 230 V, 220 V
Seite 25
Typ GI75 2H, GI150 2H 575/332 V
Seite 26