Shutting Off The Engine; Recycling The Clippings - Toro 20792 Manual

Shutting Off the Engine

Service Interval: Before each use or daily
To shut off the engine, release the blade-control bar.
Note:
Remove the electric-start button (if equipped)
whenever you leave the machine.
Important:
When you release the blade-control
bar, the engine should shut off and the blade
should stop within 3 seconds. If they do not, stop
using your machine immediately and contact an
Authorized Service Dealer.

Recycling the Clippings

Your machine comes from the factory ready to recycle
the grass and leaf clippings back into the lawn.
If the side-discharge chute is on the machine, remove
it and lock the side-discharge door; refer to
the Side-Discharge Chute (page 17)
the clippings.
Important:
Ensure that the rear plug is locked in
place. To lock the plug, raise the rear door
20), firmly push the plug in until it snaps into place
behind the tabs, and rotate the lever on the plug
to the left (Figure 21).
Figure 20
1. Rear door
Removing
before recycling
(Figure
g017463
2. Rear plug
1. Lever
Note:
To unlock the rear plug, rotate the lever on the
plug to the right (Figure
14
Figure 21
2. Tabs
21).
g010084