Replacing The Fuse; Replacing The Blade - Toro 20792 Manual

Replacing the Fuse

Electric-Start Model Only
If the battery does not charge or the engine does not
run with the electric starter, the fuse may be blown.
Replace it with a 40 A plug-in type fuse.
1. Remove the cover from the battery compartment
(Figure 42).
2. Pull out the battery and locate the fuse
42).
3. Replace the fuse in the fuse holder
Figure 42
1. Cover
2. Fuse holder
Note:
Your machine comes with a spare fuse in
the battery compartment.
4. Install the cover over the battery compartment
(Figure 42).
(Figure
(Figure 42).
g187604
3. Fuse
4. Battery compartment

Replacing the Blade

Service Interval: Yearly
Important:
You will need a torque wrench to
install the blade properly. If you do not have a
torque wrench or are uncomfortable performing
this procedure, contact an Authorized Service
Dealer.
Examine the blade whenever you run out of fuel. If the
blade is damaged or cracked, replace it immediately.
If the blade edge is dull or nicked, have it sharpened
and balanced, or replace it.
WARNING
The blade is sharp; contacting the blade can
result in serious personal injury.
Wear gloves when servicing the blade.
1. Refer to Preparing for Maintenance (page
2. Tip the machine onto its side with the air filter up.
3. Use a block of wood to hold the blade steady
(Figure 43).
4. Remove the blade, saving all mounting hardware
(Figure 44).
5. Install the new blade and all mounting hardware
(Figure 44).
23
Figure 43
20).
g005454