Setting Jumpers - Nexcom EBC 572 Series User Manual

2.3 Setting Jumpers

A jumper is the simplest kind of electric switch. It consists of two metal pins and a cap. When setting the
jumpers, ensure that the jumper caps are placed on the correct pins. When the jumper cap is placed on
both pins, the jumper is SHORT . If you remove the jumper cap, or plac e the jumper cap on just one pin,
the jumper is OPEN. Please see the following illustrations
The illustrations on the right show
a 2-pin jumper. When the jumper
cap is placed on both pins, the
jumper is SHORT . If you remove
the jumper cap, or place the
jumper cap on just one pin, the
jumper is OPEN .
These illustrations show a 3-pin
jumper. Pins 1 and 2 are SHORT.
EBC572 User' s Manual
Open (Off)
Table 2-1 : Setting Jumpers
13
Short (On)
Chapter 2