Special Safety Instructions; Technical Data - Alpha tools DS 150 Operating Instructions Manual

Anleitung DS 150 12-Spr.
The wet-and-dry grinder is a multi-function tool for
the rough and precision grinding of metals, plastics
and other materials using a selection of grinding
wheels.

Special safety instructions

1. Each time before you begin to work with the
grinding machine, carry out an acoustic test on
its grinding wheel (if a grinding wheel is in good
condition it will produce a clear tone when
tapped, e.g. with a plastic hammer). It is also
important to perform this test when fitting new
grinding wheels (risk of damage in transit).
Always have the machine run in idle mode for a
test period of at least 5 minutes. Leave the
danger zone for this period.
2. Use only grinding wheels which are marked with
data specifying the manufacturer, type of
bonding, dimensions and permissible rpm.
3. Keep grinding wheels in a dry place where the
temperature is as constant as possible.
4. Use only the supplied clamping flanges to mount
the grinding wheels.
5. The clamping flanges used to mount the grinding
wheels must be of identical size and format.
Backing layers between the clamping flange and
the grinding wheel must be made of elastic
materials, e.g. rubber, soft board, etc.
6. It is prohibited to enlarge the mounting hole in a
grinding wheel by re-drilling.
7. The workpiece supports and the adjustable
upper guards must always be positioned as
close as possible to the grinding wheel (max.
gap 3 mm).
8. Never use a grinding wheel without a safety
guard. Make sure that the following distances are
not exceeded:
- workpiece support / grinding wheel: max. 3 mm
- safety guard / grinding wheel: max. 5 mm
9. The guard holder, workpiece support and
transparent guard must all be fitted before you
use the double grinder.
10. Always pull out the power plug before changing
a grinding wheel.
11. The maximum peripheral speed of the dry
grinding wheel is:
30.10.2001 8:15 Uhr
12. Maximum permissible motor housing
13. We recommended bolting the machine in place
Layout
1. ON/OFF switch
2. Glass guard
3. Glass guard holder
4. Hood guard
5. Grinding wheel
6. Fixing screw for the workpiece support
7. Workpiece support
8. Housing base
Fitting the glass guard
Fit the glass guards to the two hood guards as
shown in the picture.

Technical data

Nominal voltage:
Power:
Idle speed n o :
Grinding wheel diameter:
Grinding wheel thickness:
Grinding wheel hole diameter:
Sound pressure level LPA:
Sound power level LWA:
Weight:
Seite 7
DS 150 = 23.15 m/s
Calculation:
peripheral speed
m/s = d x 3,14 x n
60 x 1000
d = diameter of the grinding wheel in mm
n = motor rpm
Example:
m/s = 150 x 3,14 x 2950
60 x 1000
= 23.15 m/s
temperature: 80°C
in order to guarantee a safe grinding operation.
GB
230 V~ 50 Hz
150 W
2950 rpm
150 mm
16 mm
12.7 mm
73 dB(A)
84 dB(A)
2.7 kg
7