Advertisement
Quick Links
Instruction Manual
ZBS-15 Ice Maker & Crusher
Thank you for choosing our ice maker
Please read this Instruction Manual carefully before using this product so as to ensure proper use.
After reading this manual, please keep it in a safe place and refer to it when necessary.
Advertisement
Related Manuals for Adexa ZBS-15
Summary of Contents for Adexa ZBS-15
- Page 1 Instruction Manual ZBS-15 Ice Maker & Crusher Thank you for choosing our ice maker Please read this Instruction Manual carefully before using this product so as to ensure proper use. After reading this manual, please keep it in a safe place and refer to it when necessary.
- Page 2 Safety Notice In order to avoid any accidents, please refer to following operation: 1. Disconnect power before servicing. 2. Do not pull directly on wire when plugging or unplugging the unit. 3. If ice is abnormal, please call the seller. 4.
- Page 3 Water Puncher Water Collecting Tray Ice Outlet Water Reservoir Door Ice Puncher Nameplate Water Inlet Hole Power Cord Specifications Daily Ice Output : 15-18kg/24h Ice Storage Capacity: 600g Water Reservoir Capacity : 1.8L Refrigerant R600a Dimension 340*450*453mm Before/First Use of Your Ice Maker 1.During transportation, the incline angle of the cabinet should not be over 45°...
- Page 4 Ice on making, if S at right top hand of it,then means small size ice on making if L at right bottom hand,then means large size ice on making Crushed ice in process Button Operation Press it, get to get the crushed ice. CRUSHED ICE Press it again, the unit will stop crushed ice in 5seconds Press button SMALL to turn on/off the small size ice making function...
- Page 5 Note: when temperature lower than 15degrees,S/SMALL is recommended,when temperature over 30degrees,L/LARGE ice is recommended. Step 6 Ice making cycle begins,ice will be frozen onto the evaporator fingers. Step 7 Once ice making cycle is finished,the water tray will tilt forward; the remaining water flows back to the water reservoir and the ice cubes will drop from the fingers.
-
Page 6: Troubleshooting
not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer. 3.Always use fresh water before starting ice production either at initial installation or after a long shut-off period. Troubleshooting 1. Please note, if a power failure occurs due to disconnection of the power cord, or the off power button has been pushed off during an ice making cycle, small ice chips may formed and lodge in the automatic shovel causing it to jam. - Page 7 Ice is made,however it won’t Magnetic valve is broken call for service drop from evaporator PCB is broken Ice making process is right, There is no refrigerant in call for service but no ice is made. the compressor...