Page 1
Series Commercial Flake Ice Maker Operation Manual Model: ZBS-20 To ensure use this appliance and your safety, please read the following instructions completely before operating this appliance.
CONTENT Circuit Diagram Ice full sensor Features ........2 Purple Blue Notes Before Operation..2 Switch Structure........4 Operation Procedures....5 INSTALL THE FILTER the operation is opposite with the arrowhead direction in the above Maintenance........6 Trouble And Shooting....7 Circuit Diagram......8 Install the filter......8...
Features TROUBLE AND SHOOTING ( for reference of users and technicians ) Computerized control , easy operation & high reliability TROUBLE CAUSE REMEDY 1. The voltage is lower Stainless steel exterior 1. Turn off the machine,restart than 187V Ice f laker does not when the voltage is normal.
storage container, the ice full indicator on the display panel 3.The ice flaker should be placed on >150mm will light on and the ice maker will stop automatically; horizontal and structurally sound If there is a water shortage or something wrong with the water ground and away from heat source supply system, the water shortage indicator will light on and the and corrosive gas.
Structure: Operation Procedures: 1.Unpack the package and take out the attached documents and spare parts such as the water inlet and outlet tubes, ice shovel and gaskets, etc. 2.Position the ice f laker on a well ventilated place and leave at least 150mm room between the ice maker and the wall.