Installation; Sim Card; Connections - Abus Profiline AZ6450 Installation And Operating Instructions Manual

9. Installation

9.1

SIM card

IMPORTANT:
- Disconnect the power supply before inserting the SIM card.
- Avoid touching the printed circuit of the SIM card! This could be damaged
by possible electrical discharges.
- Without a SIM card, the GSM-Interface cannot be programmed and will
therefore not work!
1. Push down the SIM card holder and fold the slot forwards.
2. Insert the SIM card.
3. Push the SIM card holder up again.
9.2

Connections

The names of the connections in the following table refer to the screw clamps on
the mainboard of the GSM-Interface.
IMPORTANT:
Before connecting, make sure that the voltage supply and the battery are
disconnected!
Connection Description
INPUT Inputs
Connect the inputs with the trigger lines/contacts.
The trigger signal is defined by jumper J15 (see also "6. Names of
components").
NR (default) = negative triggering signal (0V/COM)
Select between NC, contact "Normal Closed" NO, contact "Normal
Open".
INPUT
1 2 3 4
NC
SIM Card
2 O S
INPUT
COM
1 2 3 4
12
COM
NO