Technibel MPW1B5XA Operating Instructions Manual page 19

ADJUSTING THE AIR FLOW DIRECTION
HORIZONTAL (manual)
The horizontal air flow can be adjusted by moving the
vertical vanes to the left or right, as indicated in the following
figures.
MPW MODELS
Left
Vertical vane
KPSW MODELS
VERTICAL VANE
VERTICAL (with remote control unit)
The remote control gives you the possibility to control the
flap:
Fixed: Continous
six oscillations
position
CAUTION
Set vertical vanes to the front position during
COOLING/DRY operation if humidity is high.
If the vertical vanes are set to the left-most or right-most
position, condensation will form around the air outlet
and drip off.
• The flap automatically closes when the unit is off.
NOTES
• During the heating operation, the fan speed
will be very low and the flap will be in the
horizontal position until the air being blown
out of the unit begins to warm. Once the air
warms up, the flap position and fan speed
change to the settings specified with the
remote control.
CAUTION
Do not move the flap with your hands when the air
conditioner is running.
Right
Automatically
oscillations
(ONLY MCW-KPSW)
CAUTION
• Use the FLAP button on the remote control to adjust
the position of the flap. If you move the flap by hand,
the factual flap position and the flap position on the
remote control may no longer match. If this should
happen, shut off the unit, wait for the flap to close,
and then turn on the unit again; the flap position will
now be normal again.
• Do not have the flap pointed down during cooling
operation. Condensation may begin to form around the
air vent and drip down.
MPW MODELS
Air outlet
grille
KPSW MODELS
HOW TO ADJUST THE FLAP DIRECTION
« A »
« B »
Zone «A»
for cooling and dehumidifyng
MCW MODELS
FLAPS
8
Up
Flap
Down
DEFLETTORE
« A »
« B »
40°
Zone «B»
for heating
GB