b4Adventure Slackers TREEZONE ADVENTURE THREE HOUSE Manual page 8

STEP 5: INSTALL CENTER BRACKET AT DESIRED PLATFORM HEIGHT
YOU WILL NEED
• Bottom of treehouse can be
installed anywhere between
4 ft (1.2 m) - 8 ft (2.4 m) high off
the ground.
• NEVER install the floor of the
tree house higher than 8 ft (2.4 m) in the air.
• You will need to install the top bracket apx. 33"
above the bottom support bracket. Be sure there
is enough clearance above and below.
• Place the center bracket where you want to
climb into the tree house. Think about how the
ladder will lay against this part of the tree, and
also about what direction you want
your tree house to face.
• Insert the ratchet strap through the
slots on the back of the center bracket
and loop it around the tree until the
ratchet is centered on the back of the
tree. See steps below for
how to ratchet.
Ratchet Instructions
Pull the release lever
to open the ratchet.
8'
MAX
Thread the strap
through the bottom of
the ratchet. The
ratchet handle should
be on top so you can
move it to tighten.
MIN 33"
CLEARANCE
Pull the line through
until the ratchet is tight
against the tree.
Min Max
Tree Diameter Tree Diameter
12" 24"
center bracket
installation
Crank the ratchet to
tighten securely
against the tree.
8