Safety Instructions - tams elektronik MT-1 Manual

MT-1 | MT-2 | MT-3
In order to connect the devices you possibly need a relay (see sections
8, 9 and 10):
MT-1 relay 12 V
MT-2 relay 5 V
MT-3 relay 12 V

2. Safety instructions

Mechanical hazards
Cut wires can have sharp ends and can cause serious injuries. Watch
out for sharp edges when you pick up the PCB.
Visibly damaged parts can cause unpredictable danger. Do not use
damaged parts: recycle and replace them with new ones.
Electrical hazards

Touching powered, live components,

touching conducting components which are live due to malfunction,

short circuits and connecting the circuit to another voltage than
specified,

impermissibly high humidity and condensation build up
can cause serious injury due to electrical shock. Take the following
precautions to prevent this danger:

Never perform wiring on a powered module.

Assembling and mounting the kit should only be done in closed,
clean, dry rooms. Beware of humidity.

Only use low power for this module as described in this manual and
only use certified transformers.

Connect transformers and soldering irons only in approved mains
sockets installed by an authorised electrician.
e.g. relay 1xUm 12 V, item no. 84-61010
e.g. relay 2xUm 5 V, item no. 84-61020 and
protective diode 1N4148, item no.83-11100
e.g. relay 1xUm 12 V, Art.-Nr. 84-61010
English
Seite 5