Husqvarna S427 Operator's Manual page 6

• The machine owner should instruct all
operators in safe log splitter operation.
• Always operate the log splitter with all
safety equipment in place and all controls
properly adjusted for safe operation.
• Operate unit only when there is sufficient
light to clearly see work area.
• Operate unit only when standing in
operator zone. Unit stabilizers must be
extended before starting unit.
• Keep the operator zone and adjacent area
clear for safe, secure footing.
• Only one (1) person should operate the
logsplitter and load / unload logs.
• This unit is designed to be operated by
one person located in the operator zone.
Horizontal Operator Zone
Vertical Operator Zone
• Do not change the engine governor
settings or overspeed the engine.
• Operate the log splitter on level surfaces.
Stay off slopes and slippery surfaces.
• ALWAYS keep hands and feet away from
all moving parts during operation. Moving
parts can cut or crush body parts.
• When loading a ram-type log splitter, place
your hands on the sides of the log not at
the ends. Never place your hands or any
part of your body between a log and any
part of the log splitter.
• On ram-type log splitters, never attempt to
split more than one log at a time unless the
ram has been full extended and a second
log is needed to complete the separation
of the first log.
• On ram-type log splitters on which the logs
are not cut square, the longest portion of
the log should be rotated down and the
most square end placed against the ram.
• Never attempt to split more than one (1)
log at a time unless the ram has been fully
extended and a second log is needed to
complete the separation of the first log.
• Use only your hand to operate the log
splitter controls.
• Use wheel chocks to prevent movement of
unit during operation.
• DO NOT operate in the rain or in wet or
damp locations.
• High fluid pressures are developed
in hydraulic log splitters. Pressurized
hydraulic fluid escaping through a pin hole
opening can puncture skin and cause
severe blood poisoning. Follow these
instructions at all times.
(a) Do not operate the unit with frayed,
kinked, cracked or damaged hoses,
fittings, or tubing.
(b) Stop the engine and relieve hydraulic
system pressure before changing or
adjusting fittings, hoses, tubing, or
other system components.
(c) Do not adjust the pressure settings of
the hydraulic pump or valve.
(d) Do not check for leaks with your hand.
Leaks can be located by passing
cardboard or wood over the suspected
area. Look for discoloration. If injured
by escaping fluid, see a doctor at
once. Serious infection or reaction can
develop if proper medical treatment is
not administered immediately.
• Do not refuel the engine until it has cooled
for several minutes.
• Before starting engine ensure that control
lever is in neutral position.
• NEVER allow children to operate or play on
or near unit.
• Know the weight of logs. Limit logs to
those you can safely control and the unit
can safely handle.
• Logs should be cut with square ends
before placing on splitter.
• Position logs against end plate grips
before operating hydraulic cylinder.
- 6 -