Husqvarna S427 Operator's Manual page 12

Rear Stabilizer
Rear stabilizer must be positioned down
and locked in place when operating in the
horizontal position.
1. Remove hair pin from upper lock pin
and slide lock pin out of brackets.
2. Rotate rear
stabilizer down
until holes in
stabilizer align
with holes in
brackets.
3. Insert lock pin all
the way through
brackets and
stabilizer.
4. Reinstall hairpin.
Work Position
Horizontal
Rear stabilizer must be positioned up and
locked in place when operating in the vertical
position.
1. Remove hair pin
from upper lock
pin and slide
lock pin out of
brackets.
2. Insert lock
pin through
brackets and
through splitter
beam to lock
beam in vertical
position.
3. Reinstall hairpin.
Work Position
Vertical
Beam Assembly Lock
Locks the beam in the horizontal operating
position. To move beam to vertical operating
position:
1. Pull beam lock out until the pin clears
the mount.
2. Rotate beam lock slightly so pin does
not return to hole in mount.
3. Lift beam until it rotates to vertical
position.
To move beam to horizontal position:
4. Set the rear stablilzer to the correct
position.
5. Carefully rotate beam down until seated
on lock bracket.
6. Turn beam lock until pin lines up with
hole in lock bracket and release.
7. Ensure that the beam lock pin fully
engages in bracket.
CAUTION! Beam assembly is
heavy. Use care when moving between
vertical and horizontal positions.
- 12 -