Devolo dsl+ 1100 duo User Manual page 16

16
Connection and installation
Make sure that the new IP addresses are not already being used in your network
and that they lie within your existing range of IP addresses.
Configuration under SUSE Linux—permanent installation
The following procedure can only be executed as "root".
For the permanent installation under SUSE Linux, create a text file with the nec-
essary information for the adapter. Open any text editor (e.g. edit, pico) and
enter the following information:
b
b
Make sure that the new IP addresses are not already being used in your network
and that they lie within your existing range of IP addresses!
To define a gateway, create the file /etc/sysconfig/network/ifroute-eth0
and enter default 192.168.0.253
Make sure that the IP address is the same as that for the dsl
cases the router in the network is the gateway.
A dsl
If the dsl
interface using Yast.
Configuration under Debian Linux—permanent installation
Please note that this procedure can only be executed as "root".
Under Debian Linux, append the following information to the file /etc/inter-
faces :
|
devolo dsl+ 1100 duo
|
if IP addresses are to be assigned dynamically:
BOOTPROTO='dhcp'
STARTMODE='hotplug'
Finally, save the file under the unique identifier of the network adapter
as follows: /etc/sysconfig/network/ifcfg-eth0
if IP addresses are to be assigned statically:
BOOTPROTO='static'
STARTMODE='hotplug'
IPADDR='192.168.0.1'
NETMASK='255.255.255.0'
Finally, save the file under the unique identifier of the network interface
as follows: /etc/sysconfig/network/ifcfg-eth0
+
1100 duo connected by USB cannot be configured graphically with Yast.
+
1100 duo is connected via Ethernet you can configure the network
|
+
1100 duo. In most