Table of Contents
Advertisement
Windows XP
2.2.3
Installation of the USB driver on a Mac
When using the USB connection under Mac operating systems, the USB drivers
are installed automatically.
2.2.4
Installation of the USB driver under Linux
If you have connected the dsl
the router as a network interface, which means that the dsl
treated like any other network interface (e.g. a PCI network card).
Please note that the command
Entering the command ifconfig -a displays all network interfaces. Each net-
work connection has an identifier that consists of 'eth' and a unique number
(e.g. "0" for the first device, "1" for the second, etc.).
Configuration—single application (for installation test)
All of the IP addresses named here are examples only. They refer to the first net-
work interface eth0.
After listing all of the network interfaces with the command ifconfig -a, con-
tinue with the configuration with the following entry ifconfig eth0 198.168.0.1
netmask 255.255.255.0 up.
The correct driver can be found on the devolo product CD. Activate the 'CD-
ROM drives' option and deactivate all other boxes. Then click Next. The
driver installation is started.
Click Next to continue the installation.
By clicking Finish you'll exit the installation.
Put the devolo product CD in your CD-ROM drive.
Windows XP starts the hardware wizard and reports that new hardware has
been detected.
In the following dialog window activate the option 'Install the software
automatically (Recommended)'. Click Next. The driver installation is
started.
By clicking Finish you'll exit the installation.
|
Connection and installation
+
1100 duo via USB, your computer will recognise
can only be executed as "root".
ifconfig -a
15
+
1100 duo is to be
|
devolo dsl+ 1100 duo
|
Advertisement
Table of Contents
