Abus IPCS84510 User Manual Software page 60

Important safety information
All guarantee claims are invalid in the event of damage caused by non-
compliance with this user manual. We cannot be held liable for resulting
damage.
We cannot be held liable for material or personal damage caused by improper
operation or non-compliance with the safety information. All guarantee claims
are void in such cases.
Dear Customer,
The following safety information and hazard notes are not only intended to protect your health
but also to protect the device from damage. Please read the following points carefully:

There are no components inside the product that require maintenance by the operator.
Opening or dismantling the product invalidates the CE certification and guarantee
claims/warranty.

The product may be damaged if it is dropped, even from a low height.
Avoid the following adverse conditions during operation:

Moisture or excess humidity

Extreme heat or cold

Direct sunlight

Dust or flammable gases, vapours or solvents

Strong vibrations

Strong magnetic fields (e.g. next to machines or loudspeakers)

The camera must not be installed on unstable surfaces.
General safety information:

Do not leave packaging material lying around. Plastic bags, sheeting, polystyrene packaging,
etc. can pose a danger to children if played with.

The video surveillance camera contains small parts which could be swallowed and must be
kept out of the reach of children for safety reasons.

Do not insert any objects into the device through the openings.

Only use replacement devices and accessories that are approved by the manufacturer. Do not
connect any non-compatible products.

Please pay attention to the safety information and user manuals for the other connected
devices.

Check the device for damage before putting it into operation. Do not put the device into
operation if you identify any damage.

Adhere to the normal voltage limits specified in the technical data. Higher voltages could
destroy the device and pose a health risk (electric shock).
When installing the device in an existing video surveillance system, ensure that all
devices have been disconnected from the mains power circuit and low-voltage circuit.
If in doubt, have a specialist technician carry out assembly, installation and connection
of the device. Improper or unprofessional work on the power supply system or domestic
installation puts both you and other persons at risk.
Connect the installations so that the mains power circuit and low-voltage circuit always
run separately from each other. They should not be connected at any point or become
connected as a result of a malfunction.
60