Power Unit Features - Bosch MUM6N10UG Instruction Manual

GETTING STARTED
The operation of your Bosch Universal
Kitchen Machine is summarized below.
Specific instructions for each of the
attachments included with your machine
are listed separately. Please read the
specific instructions thoroughly before using
that attachment, paying particular attention
to the IMPORTANT SAFEGUARDS and
WARNINGS provided.
1. Place power unit on suitable work
surface.
Before using the machine with any of
the attachments, the power unit should
be placed on a suitable work surface.
The surface should be sturdy, smooth
and clean; make sure that there is no
flour or oil on the surface. A clean,
smooth surface will provide the best
footing for the suction cup feet on the
power unit and will limit slipping and/or
"walking".
2. Plug power unit into power supply.
Unwind the power unit's cord to
appropriate length and plug it into a
convenient nearby receptacle.
3. Remove motor drive cover.
If necessary, remove motor drive cover
from drive that will be used and place it
on drive that will not be used. The
cover, when placed on the high-speed
drive, can be locked in position by
pressing down, see figure 2c.
10
4. Select attachment to be used.
Select the attachment you wish to use
and place on power unit, See specific
instructions for attachment selected on
pages listed below:
Attachment
Mixing bowl w/dough hook
Mixing bowl w/twin whisks
Blender
5. Operate unit with rotary switch.
Once the attachment is in place, the
speed of its moving components can
be controlled through the use of the
rotary switch at the front of the power
unit. See figure 2a. The rotary switch
has five positions:
a. "M", a momentary "pulse" position
that provides full speed and power
for the time it is held in position.
b. "0/off", the Off position.
c. Four speeds labeled 1, 2, 3 and 4.
Speed 1 is the lowest speed.
The speed increases with each
succeeding step up to the highest
speed, speed 4.
All models of the Bosch Universal
Kitchen Machines incorporate a built-in
safety cutout switch to protect the
motor against overheating. If the safety
becomes activated, the power unit will
stop. If the power unit should stop even
though there is power to the unit see
TROUBLESHOOTING at the back of
this manual.
Pages
13
14
19