Choosing The Proper Location; Electricity; Flooring; Ambient Temperature - LG LSEL6337 Series Owner's Manual

us_main.book.book Page 12 Wednesday, February 3, 2021 9:14 AM
12 INSTALLATION
NOTE
• Your range is heavy and can be installed on soft
floor coverings such as cushioned vinyl or
carpeting. Use care when moving the range on
this type of flooring. Use a belt when moving the
range to prevent damaging the floor. Or slide
the range onto cardboard or plywood to avoid
damaging the floor covering.
Choosing the Proper
Location

Electricity

The range should always be plugged into its own
individual properly grounded electrical outlet.
• This prevents overloading house wiring circuits
which could cause a fire hazard from overheated
wires.
• It is recommended that a separate circuit
serving only this appliance be provided.

Flooring

CAUTION
• Use an insulated pad or 1/4 in. (0.64 cm) plywood
under the range if installing the range over
carpeting.

Ambient Temperature

CAUTION
• Make sure wall covering, countertop and
cabinets around the range can withstand the
heat (up to 194 °F) generated by the range.
Discoloration, delamination or melting may
occur. This range has been designed to comply
with the maximum allowable wood cabinet
temperature of 194 °F.
• Before installing the range in an area covered
with linoleum or other synthetic floor covering,
make sure the floor covering can withstand
temperatures of at least 200 °F (93 °C).
Additional Installation
Requirements
Mobile Home
The installation of this range must conform to the
Manufactured Home Construction and Safety
Standard, Title 24 CFR, Part 3280 (formerly the
Federal Standard for Mobile Home Construction
and Safety, Title 24, HUD Part 280), or when such
standard is not applicable, the Standard for
Manufactured Home Installations, ANSI A225.1/
NFPA 501A or with local codes.
• When this range is installed in a mobile home, it
must be secured to the floor during transit. Any
method of securing the range is adequate as
long as it conforms to the standards listed
above.
• A four-wire power supply cord or cable must be
used in a mobile home installation.