Important Facts Read Before Commencing Installation - Stuart Turner MAINSBOOST MB 100CV Installation, Operation & Maintenance Instructions Manual

2 IMPORTANT FACTS
A Water temperature
This unit is designed for cold water applications only which should not exceed the
following values:
2.11 The maximum allowable water temperature is 35
2.12 The minimum allowable water temperature is 4
B Pipework - General
2.13 Secure pipework: Ensure pipework to and from the Mainsboost is
independently supported & clipped to prevent forces being transferred.
2.14 Flux: Solder joints must be completed and flux residues removed prior to
completing the installation (flux damage will void any warranty).
2.15 Pipework design: Care should be taken in the design of pipework runs to
minimize the risk of air locks e.g. use drawn bends rather than 90
C Plumbing Installation Regulations
2.16 The plumbing installation must comply with the current water and building
regulations.
2.17 The plumbing installation must be installed by a qualified person.
D Mainsboost vessel
2.18 Ensure the Mainsboost vessel is installed correctly before operating the unit,
to avoid damage.
The Mainsboost vessel is pressurised to a pre-set level at the factory see
Section 7.11 - Commissioning for details.
READ BEFORE COMMENCING INSTALLATION
Do not attempt to dismantle the Mainsboost vessel
- 6 -
C.
o
C.
o
bends.
o