Table of Contents
Advertisement
en Troubleshooting
Fault
The time does not appear in the
display when the appliance is
switched off.
lights up in the display and no
settings can be made on the ap-
pliance.
appears in the display.
A message with appears in the
display, e.g.
-
.
Replacing the oven light bulb
If the light in the cooking compartment fails, change
the oven light bulb.
Note: Heat-resistant, 25-watt, 230 V halogen bulbs are
available from the after-sales service or specialist retail-
ers. Only use these bulbs. Hold the new halogen bulbs
only with a clean, dry towel. This increases the service
life of the bulb.
WARNING ‒ Risk of burns!
The appliance gets very hot.
▶ Never touch the inside surfaces of the cooking
compartment or the heating elements while they
are hot.
▶ Always allow the appliance to cool down.
▶ Keep children at a safe distance.
WARNING ‒ Risk of electric shock!
When replacing the cooking compartment
bulb, be aware that the bulb socket contacts
are live.
▶ Before replacing the bulb, unplug the appliance
from the mains or switch off the circuit breaker in
the fuse box.
18
Cause and troubleshooting
The basic setting has been changed.
Change the basic setting for the time display.
▶
Childproof lock is activated.
Use the
button to deactivate the childproof lock.
▶
Cleaning recommendation
Run the cleaning function fully.
▶
→ "EcoClean", Page 13
You can temporarily dismiss the information in the display by pressing any
button.
→ "Cleaning recommendation", Page 13
Electronics fault
Press
.
1.
If necessary, reset the time on the clock.
‒
a If the fault was a one-off, the error message disappears.
If the error message appears again, call the after-sales service. State the ex-
2.
act error message and the E no. for your appliance in full.
→ "Customer Service", Page 19
Requirements
¡ The appliance is disconnected from the power sup-
ply.
¡ The cooking compartment has cooled down.
¡ You have a new halogen bulb to replace the old one.
Place a tea towel in the cooking compartment to
1.
prevent damage.
Turn the glass cover anti-clockwise to remove it.
2.
Pull out the halogen bulb without turning it.
3.
Insert the new halogen bulb and press it firmly into
4.
the socket.
Make sure the pins are positioned correctly.
Depending on the appliance model, the glass cover
5.
may have a sealing ring. Attach the sealing ring.
Screw in the glass cover.
6.
Remove the tea towel from the cooking compart-
7.
ment.
Connect the appliance to the power supply.
8.
Advertisement
Table of Contents
