Buffalo AirStation MIMO WZR-G108 Quick Setup Manual page 3

Step 2 - Connecting Cables to the AirStation
1. Power down the cable or DSL modem and the computer which will be
used to configure the AirStation router.
2. Plug the cable or DSL's LAN Ethernet cable into the AirStation's WAN
port. Initially, you may need to unplug this cable from your computer,
hub or other router.
3. Plug the provided Ethernet cable into a LAN port on the AirStation and
plug the other end into your computer's Ethernet adapter's (NIC)
port. If you plan to initially configure the AirStation wirelessly (not
recommended), you may skip this step.
4. Power on your cable or DSL modem and wait one full minute, Power
on the AirStation router, wait one full minute, and then power on the
computer which will be used to configure the AirStation. If the red
DIAG light on the AirStation is lit or flashing after several minutes
of being powered on, please consult Buffalo Technology Technical
Support.
Internet
Cable/DSL
Modem
LAN Cable LAN Cable
(Straight CAT 5)
3
Wireless
Laptop
AC Power