Putting Into Operation; Energy Saving Tips - Bonnet Neve MULTIFREEZ PLUS EFFICIA User Instructions

Modello - Modèle - Model
Modell - Modelo
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante
12. SHELVING ASSEMBLY
The shelves can be adjusted to the desired height.
Never try to adjust the position of a shelf with
products on it.
Check the shelf is stable before placing objects on it.
To adjust the height of the shelf:
1. Position the shelf supports at the same height
(A).
2. Place the shelf on the supports (B).

13. PUTTING INTO OPERATION

If the cabinet has been sharply tilted while being sited or for mounting of accessories, it must be left to stand
for at least three hours before being started to allow the lubricating oil to settle in the compressor.
Failure to do so can cause total destruction of the compressor refrigerating system.
Check that the voltage on the identification plate is the same as that of the network.
THE ELECTRICAL SUPPLY LINE TO WHICH THE REFRIGERATOR WILL HAVE
TO BE CONNECTED IS TO BE PROTECTED BY A VERY SENSITIVE
DIFFERENTIAL SWITCH
• (MULTIFREEZ PLUS 1D/2D/ 3D:
• (MULTIFREEZ PLUS 4D: Rc=25 A, Dc= 30
IT IS ALSO TO BE LINKED TO THE GENERAL EARTHING PLANT.
Earthing is necessary and compulsory by law.
Absolutely never use reduction units, patch cords, adapters or multiple socket
outlets to connect the counter. DIRECTLY connect the equipment to the mains.
The cable should be fully extended and located where it is unilikely to be struck, caught or stepped on, away from water
and the other liquids and heat sources and must not be damaged. In case of breakage of the power cable of the cabinet,
it must be replaced by the manufacturer or by instruction it change of it.
Follow the manufacturer's instructions to install the unit, using qualified personnel and complying with the electrical
regulations for the specific country.
Incorrect installation may cause injury and damage; the manufacturer is not liable for this.
The manufacturer disclaims all responsability for any damage to people or things due to incorrect
observance of this rule.

14. ENERGY SAVING TIPS

• Install the appliance in a dry, well-ventilated room away from heat sources (radiator, cooking surface and so on) and in a position
out of direct sunlight.
• Follow the installation instructions to ensure adequate ventilation. Insufficient ventilation to the back of the appliance causes an
increase in energy consumption and reduces cooling efficiency.
• The internal temperature of the appliance depends on the room temperature, how often the doors are opened and where the
appliance is placed. These factors have to be taken into account when setting the thermostat. Only open the doors when strictly
necessary.
• Let hot food and drink cool down before placing them in the appliance.
• The positioning of the shelves in the fridge has no effect on energy efficiency.
• The fridge compartment light system uses a LED light, which at the same time ensures more efficient lighting and reduced energy
consumption.
15. PROLONGED SWITCH OFF
When the unit is not used for a long time, please take note of the following procedures:
• Unplug the unit.
• Clean and dry the tank well.
• Leave the glass door open to avoid possible formation of bad odours.
• Cover the unit with a curtain, place it in a dry room and sheltered from the atmospheric agents.
MULTIFREEZ PLUS EFFICIA
MULTIFREEZ PLUS MODULAR
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
A
Rc=16A,Dc=30mA)
mA);
B
1
2
2 1 / 6 8
PAGE
UM000458
N° DOC