Install Memory Modules - Synology RS2821RP+ Hardware Installation Manual

Install Memory Modules

Optional Synology memory modules are designed to expand the memory of your Synology NAS. Follow the steps
below to install, check, or remove a memory module on your Synology NAS.
The following table shows the memory configuration for best practice:
U27 U28
4 GB -
4 GB 4 GB
8 GB 8 GB
16 GB 16 GB
Note:
No product warranty or technical support will by provided by Synology if a non-Synology memory
module is used for memory upgrade. A list of Synology-compatible memory modules can be found here.
To install the RAM module
1 Shut down your RS2821RP+. Disconnect all cables connected to your RS2821RP+ to prevent any possible
damage.
2 Remove the screw on the back of you RS2821RP+. Slide open the rear top cover, then lift it up and put it
aside.
Note:
When you remove the rear top cover, sensitive internal components are exposed. Avoid touching
anything other than the memory assembly when removing or adding memory.
3 The memory slots are labeled as below.
14 Chapter 2: Hardware Setup
Total Memory
4 GB
8 GB
16 GB
32 GB
U27
U28