Table of Contents
Advertisement
4 Insert the new memory module in the slot:
a Push the retaining clips on the slot out to the sides.
b Align the notch on the gold edge of the module with the notch in the memory slot.
c Apply firm and even pressure to push down the memory module. The retaining clips will snap into position
when the module is inserted correctly.
Note:
Hold the memory module by its edges and avoid touching the gold connectors.
5 Place the rear top cover back and slide it into secure position:
a Align the hexagons at the side of the rear top cover with the slots on the chassis' edge, place it back and
push it to slide it back into position.
b Put back and fasten the screw you removed in step 2.
To confirm that your RS2821RP+ recognizes the new memory capacity
1 Install DiskStation Manager (DSM). Please see "Install DSM on Synology NAS" for more information.
2 Sign in to DSM as admin or a user belonging to the administrators group.
3 Go to
Control Panel
If your Synology NAS does not recognize the memory or does not start up successfully, please make sure that
the memory module is installed correctly.
15 Chapter 2: Hardware Setup
Info Center
Total Physical
>
and check
a
b
c
Memory.
Advertisement
Table of Contents
