Chapter 2: Hardware Setup; Tools And Parts For Drive Installation; Install Drives - Synology RS2821RP+ Hardware Installation Manual

Hardware Setup

Tools and Parts for Drive Installation

Please prepare below tools and parts before setting up your Synology NAS:
• A screwdriver
• At least one 3.5" or 2.5" SATA drive (please visit
models)
Warning:
If you install a drive that contains data, the system will format the drive and erase all existing data.
Please back up any important data before installation.
• Rail mounting kit (please see the Optional Accessories section to find out the suitable rail kit for cabinet
installation)
Warning: We suggest mounting your Synology NAS on a cabinet before installing any drives since the heavy
weight will increase the installation difficulty.

Install Drives

Please follow the steps below for drive installation:
1 Open the drive tray.
b
a Press the small button located on the left side of the drive tray handle. The drive tray handle pops out.
b Pull the drive tray out by its handle as shown above.
2 Install drives:
• For 3.5" drives: Place the drive in the drive tray. Turn the tray upside down and tighten screws into the four
spots indicated below to secure the drive in place.
12
Synology Products Compatibility List
a
2
Chapter
for compatible drive