Disposal - Siemens BE525LMS0H User Manual And Installation Instructions

en Disposal
Fault
The appliance is not working.
Food takes longer than usual to
heat up.
Turntable grates or grinds.
Microwave mode is cancelled.
The appliance is not in operation.
A cooking time is shown in the
display.
Three zeros flash on the display.
An is shown on the display.
The message appears on the
display.
14 Disposal
Find out here how to dispose of old appliances cor-
rectly.
14.1 Disposing of old appliance
Valuable raw materials can be reused by recycling.
Dispose of the appliance in an environmentally
▶
friendly manner.
Information about current disposal methods are
available from your specialist dealer or local author-
ity.
16
Cause and troubleshooting
The circuit breaker is faulty.
Check the circuit breaker in the fuse box.
▶
There has been a power cut.
Check whether the lighting in your kitchen or other appliances are working.
▶
Malfunction
Switch off the fuse in the fuse box.
1.
Switch the fuse back on after approx. 10 seconds.
2.
a If the fault was a one-off, the message disappears.
If the message appears again, call the after-sales service. Please specify the
3.
exact error message when calling.
→ "Customer Service", Page 17
Door is not fully closed.
Check whether food remains or foreign material are trapped in the door.
▶
The microwave power setting is set too low.
Set a higher microwave power setting. → Page 10
▶
You have placed a larger amount of food than normal in the appliance.
Set a longer cooking time.
▶
You need double the time when you have double the amount.
The food is colder than usual.
Turn or stir the food from time to time during cooking.
▶
There is dirt or foreign objects in the area of the turntable drive.
Clean the roller ring and recess in the cooking compartment.
▶
Appliance has a fault.
If this fault recurs, call the after-sales service.
▶
The settings area has been activated accidentally.
Press ⁠ .
▶
was not pressed after the setting was implemented.
Press or delete the setting by pressing
▶
There has been a power cut.
Reset the time.
▶
→ "Initial configuration", Page 8
Demo mode is activated.
Fault in the automatic door opening system.
1. Switch off the appliance.
Wait for 10 minutes.
2.
Switch the appliance on again.
3.
If this fault recurs, call the after-sales service.
▶
⁠ .
This appliance is labelled in accord-
ance with European Directive
2012/19/EU concerning used elec-
trical and electronic appliances
(waste electrical and electronic equip-
ment - WEEE).
The guideline determines the frame-
work for the return and recycling of
used appliances as applicable
throughout the EU.