Table of Contents
Advertisement
5.
To remove the remainder of the display subcomponents, you must remove the display assembly from
the computer. To remove the display assembly, disconnect the antenna cables from the WLAN module
(1).
6.
Remove the cables from the clips around the fan (2), and the disconnect the display cable (3).
7.
Remove the five Phillips M2.5 × 4.0 screws (1) that secure the display assembly to the computer.
8.
Rotate the display to open the hinges (2).
9.
Separate the display assembly from the computer (3).
10.
If you need to remove the hinges from the display enclosure:
a.
Remove the trim pieces (1).
b.
Remove the two Phillips M2.0 × 2.5 screws (2) from each hinge.
50
Chapter 5 Removal and replacement procedures for authorized service provider parts
Advertisement
Table of Contents
