Table of Contents
Advertisement
3.
Use the following illustration to determine proper adhesive installation locations on the display rear
cover. Before installing the display panel, be sure to connect the display cable to the back of the panel.
The display panel tape is available in the LCD Support Kit as spare part number M23559-001.
4.
If you need to remove the camera module:
Use a tool to lift up evenly across the module and peel the module up from the display back cover
▲
(1), and then disconnect the cable from the reverse ZIF connector on the module (2). The camera
module is available as spare part number M29582-001 for HD cameras and M27887-001 for IR
cameras. The microphone module (for use in models without a camera module) is available as
spare part number M27886-001.
NOTE:
For installation, note that the cable routes under the camera module before it connects to
the module.
Component replacement procedures
49
Advertisement
Table of Contents
