Advertisement
Quick Links
Operation Manual
SKD-5 – Pressure Switch
50612, 51249
Illustration similar, may vary depending on model
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Due to further developments, illustrations, functioning steps and technical data can differ insignific -
antly.
Updating the documentation
If you have suggestions for improvement or have found any irregularities, please contact us.
Advertisement
Related Manuals for WilTec SKD-5
Summary of Contents for WilTec SKD-5
- Page 1 Operation Manual SKD-5 – Pressure Switch 50612, 51249 Illustration similar, may vary depending on model Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Due to further developments, illustrations, functioning steps and technical data can differ insignific - antly.
- Page 2 All rights reserved. The WilTec Wildanger Technik GmbH cannot be held accountable for any possible mistakes in this operating manual, nor in the diagrams and figures shown.
- Page 3 Electrical connection The electrical connection is made at a 230 V ~ 50 Hz socket outlet with grounding contact. Fuse pro- tection at least 10 A. © by WilTec Wildanger Technik GmbH Item 50612, 51249 Page 3 http://www.WilTec.de http://www.aoyue.eu...
- Page 4 Water pressure switch actuated + water flow switch not actuated = normal switch-off (delay of approx. 3–8 sec. until switch-off) Water pressure switch not actuated + water flow switch actuated = pump on © by WilTec Wildanger Technik GmbH Item 50612, 51249 Page 4 http://www.WilTec.de...
- Page 5 The water flow switch at the pump control input is permanently actuated. This can be caused by contamination, calcification or a foreign body. (An optical check con firms this problem and can be corrected by cleaning.) © by WilTec Wildanger Technik GmbH Item 50612, 51249 Page 5 http://www.WilTec.de...
- Page 6 2 bar. Before the start of the machine, the suction hose and the pump filling must checked! © by WilTec Wildanger Technik GmbH Item 50612, 51249 Page 6 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
- Page 7 Pump operates inter- Board is damaged. There is a leak with less than mittently. Pump does not have sufficient pres- 0.6 ℓ/min loss. sure. © by WilTec Wildanger Technik GmbH Item 50612, 51249 Page 7 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
- Page 8 All WilTec electric devices that fall under the WEEE regulations are labelled with the crossed-out wheeled waste bin logo. This logo indicates that this electric equipment must not be disposed with the domestic waste.