Table of Contents
Advertisement
Quick Links
Operation Manual
SKD 3
Pressure switch
-Artikel 51248 - 51245 -
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Due to further developments, illustrations, functioning steps and technical data can differ insignificantly.
Updating the documentation
If you have suggestions for improvement or have found any irregularities please contact us.
© by WilTec Wildanger Technik GmbH
Seite 10
http://www.WilTec.de
http://www.aoyue.eu
Version 7.2017
http://www.teichtip.de
Advertisement
Table of Contents
Related Manuals for WilTec SKD 3
Summary of Contents for WilTec SKD 3
- Page 1 Due to further developments, illustrations, functioning steps and technical data can differ insignificantly. Updating the documentation If you have suggestions for improvement or have found any irregularities please contact us. © by WilTec Wildanger Technik GmbH Seite 10 http://www.WilTec.de http://www.aoyue.eu Version 7.2017...
- Page 2 The information contained in this document is subject to change without prior notice. No part of this document can be copied or duplicated in another form without the prior written consent of Wiltec Wil- danger Technik GmbH. The Wiltec Wildanger Technik GmbH assumes no liability for any errors in this user manual or the connection diagram.
- Page 3 (installing an alarm system, reserve pump). • In case of malfunction the repair work can be carried out only by a qualified electricial or the WilTec-service. © by WilTec Wildanger Technik GmbH Seite 12 http://www.WilTec.de http://www.aoyue.eu Version 7.2017...
- Page 4 B: Water flow switch in the pump control input is permanently actuated. This can be caused by con- tamination, calcification or a foreign body. (An optical test confirms this problem and can be cleansed by cleaning.) © by WilTec Wildanger Technik GmbH Seite 13 http://www.WilTec.de http://www.aoyue.eu...
- Page 5 0,5 bar higher than the cut-in pressure, so it must reach at least 2 bar. Before starting the device check the suction hose and the pump filling! Pumpenfüllung prüfen! © by WilTec Wildanger Technik GmbH Seite 14 http://www.WilTec.de http://www.aoyue.eu Version 7.2017 http://www.teichtip.de...
- Page 6 The pump has not sufficient pressure Intermittent pump Circuit board is damaged There is a leak with more operation( pump runs The pump has not sufficient pressure than 0,6 l/min loss intermittently) © by WilTec Wildanger Technik GmbH Seite 15 http://www.WilTec.de http://www.aoyue.eu Version 7.2017 http://www.teichtip.de...
- Page 7 All Wiltec electric devices that fall under the WEEE regulations are labelled with the crossed-out wheeled waste bin logo. This logo indicates that this electric equipment must not be disposed with the domestic waste.
Need help?
Do you have a question about the SKD 3 and is the answer not in the manual?
Questions and answers