Table of Contents
Advertisement
en Troubleshooting
Fault
The control ring has fallen out of
the mount in the control panel.
The control ring is difficult to turn. There is dirt below the control ring.
The interior lighting does not
work.
Maximum operating time
reached.
A message with "D" or "E" ap-
pears in the display, e.g. D0111
or E0111.
The cooking result is not satis-
factory.
17.2 Replacing the oven light bulb
If the light in the cooking compartment fails, change
the oven light bulb.
Note: Heat-resistant, 40-watt, 230 V halogen bulbs are
available from the after-sales service or specialist retail-
ers. Only use these bulbs. Hold the new halogen bulbs
only with a clean, dry towel. This increases the service
life of the bulb.
WARNING ‒ Risk of burns!
The appliance and its parts that can be touched be-
come hot during use.
Caution should be exercised here in order to avoid
▶
touching heating elements.
Young children under 8 years of age must be kept
▶
away from the appliance.
20
Cause and troubleshooting
The control ring has been detached.
Insert the control ring into the mount in the control panel.
1.
Push the control ring into the mount so that it clicks into place and can be
2.
turned.
The control ring can be removed.
Note: To ensure that the mount remains stable, do not remove the control ring
too often.
To loosen the control ring, press on the outer edge of the control ring.
1.
a The control ring tilts and is easier to grip.
Remove the control ring from the mount.
2.
Clean the control ring and its mount on the appliance carefully using soapy
3.
water and a dish cloth. Dry with a soft cloth.
Do not use any harsh or abrasive cleaning agents.
Do not soak the control ring.
Do not clean the control ring in the dishwasher.
The halogen lamp is defective.
Change the oven light bulb.
▶
→ "Replacing the oven light bulb", Page 20
To prevent an unwanted permanent operation, the appliance automatically stops
heating after several hours if the settings are unchanged. A message appears in
the display.
The point at which the maximum operating time is reached is determined by the
corresponding settings for an operating mode.
To continue the operation, press any touch field and turn the control ring.
1.
If you do not need to use the appliance, use
2.
Tip: To prevent the appliance from switching off when you do not want it to, set
a cooking time.
→ "Setting the cooking time", Page 11
The electronics have detected a fault.
1.
Switch the appliance off and on again.
a If the fault was a one-off, the message disappears.
If the message appears again, call the after-sales service. Please specify the
2.
exact error message when calling.
→ "Customer Service", Page 21
Settings were unsuitable.
Setting values, e.g. temperature or cooking time, depend on the recipe, quantity
and food.
Next time, set lower or higher values.
▶
Tip: A lot of information about the food preparation and corresponding set-
ting values can be found on our website www.bosch-home.com.
WARNING ‒ Risk of electric shock!
When changing the bulb, the bulb socket contacts are
live.
Before replacing the bulb, ensure that the appliance
▶
is switched off in order to prevent a potential electric
shock.
Also unplug the appliance from the mains or switch
▶
off the circuit breaker in the fuse box.
Requirements
¡ The appliance is disconnected from the power sup-
ply.
¡ The cooking compartment has cooled down.
¡ You have a new halogen bulb to replace the old one.
Place a tea towel in the cooking compartment to
1.
prevent damage.
Turn the glass cover anti-clockwise to remove it .
2.
to switch it off.
Advertisement
Table of Contents
