Building Under A Continuous Worktop; Removing The Lid; Preventing Heat Build-Up - Miele PG 8591 Operating Instructions Manual

Installation
Removing the
lid
Steam condenser
Preventing heat
build-up
138

Building under a continuous worktop

To build the machine under a continuous worktop the lid must be
removed as follows:
Unscrew both securing screws from the lid at the back of the

machine.
Open the door.

Unscrew the left and right fixing screws.

Lift the lid off.

To avoid steam damage to the worktop the protective foil supplied
(25 x 58 cm, self-adhesive) must be applied underneath the
worktop in the area of the steam condenser.
During the drying phase, the hot exhaust air from the wash cabinet is
released into the surrounding environment through the steam
condenser at the rear of the machine. Sufficient ventilation must be
ensured to prevent heat build-up and excessive condensation.
Leave a minimum distance of 10 mm for air exchange between the

machine and the worktop.
If necessary ventilation grilles should be fitted in the side units.
