Troubleshooting - AEG FD395V User Manual

programmes at least twice a month to
prevent the buildup.
10.5 Removal of foreign
objects
Check the filters and the sump after each
use of the dishwasher. Foreign objects
(e.g. pieces of glass, plastic, bones or
toothpicks, etc) decrease the cleaning
performance and can cause damage to
the drain pump.

11. TROUBLESHOOTING

WARNING!
Improper repair of the
appliance may pose a
danger to the safety of the
user. Any repairs must be
performed by qualified
personnel.
The majority of problems that can
occur can be solved without the need
Problem and alarm code
You cannot activate the appliance.
The programme does not start.
The appliance does not fill with water.
• The indicator
intermittently.
• Acoustic signal sounds 1 time in‐
termittently.
Possible cause and solution
•
•
•
•
•
•
•
flashes 1 time
•
•
•
1. Disassemble the filters system as
instructed in this chapter.
2. Remove any foreign objects by hand.
CAUTION!
If unable to remove the
objects, contact an
Authorised Service
Centre.
3. Reassemble the filters as instructed
in this chapter.
to contact an Authorised Service
Centre.
Refer to the below table for information
on possible problems.
With some problems, the dedicated
indicator flashes intermittently to indicate
a malfunction and the alarm code.
Make sure that the mains plug is connected to
the mains socket.
Make sure that there is no damaged fuse in
the fuse box.
Make sure that the appliance door is closed.
If the delay start is set, cancel the setting or
wait for the end of the countdown.
The appliance recharges the resin inside the
water softener. The duration of the procedure
is approximately 5 minutes.
Make sure that the water tap is open.
Make sure that the pressure of the water sup‐
ply is not too low. For this information, contact
your local water authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is not
clogged.
Make sure that the inlet hose has no kinks or
bends.
ENGLISH 43